"If the PIR is accidentally triggered, there may be objects in the motion detection area that can easily set off the alarm, such as an air conditioner running or a car. Solution: 1. it is recommended not to install the camera on the side of the road or in crowded scenes. 2. try not to point the camera at a heat source similar to the outdoor unit of the air conditioner to avoid accidental triggering. 3. adjust the sensitivity of the motion detection and reduce the motion detection range of the camera. 4. the alarm schedule can be adjusted and the time period of the camera alarm can be divided reasonably." 

1. the noise generated by the intercom is generally caused by close range operation and the camera and speaker equipment cannot be brought too close. 2. the recording distance set by the camera is farther and the sensitivity is higher, and it is easy to penetrate the microphone when sharp anomalies are nearby. 3. it may also be the noise generated by the operation of the motor or the noise of the electricity, which is generally a normal phenomenon and does not affect the use. 

Detection range: The best distance is 8 m, the maximum distance is 13 metres, 110 degrees. 

The red light of the indicator light is always on: The camera is abnormal or the network is abnormal, Solution: Please long press the reset button of the unit to reset it and try to connect to the network again. The indicator light flashes red slowly: The camera is in network configuration mode, solution: Please try to connect to the network. The indicator light is always blue: The camera is running normally, Solution: Please use the camera The blue light of the indicator lamp flashes slowly: The camera switches to AP network configuration mode or displays a preview, solution: The camera is in a normal state The indicator light flashes red/blue quickly: The camera connects to the network, the solution: The camera is in a normal state 

Operating temperature: -20℃~60℃ (14℉-122℉) 

1. first make sure if an alarm event has been triggered, you can check if there is a message in the message log. 2. confirm the mobile phone settings: Make sure that the notification permission of the APP software is enabled and notification is allowed. 3. confirm the APP settings: Open the APP, click in the settings of the device and make sure that "Receive Alarm Push" is activated 

Not supported, please use the mobile phone to connect 

No, the security can only connect to your phone through Cloudedge APP. 

No, the security can only connect to your phone through Cloudedge APP.